![]() ![]() The USB-C Super Fan Controller comes with the pre-loaded code. The documentation below consists of the 3D Files and Code that you can refer to.It contains two indicator LEDs, RED and BLUE, red is for low battery and Blue is for full charging.It has two modes that can be triggered on single and double pressing the toggle switch, on the first press this setup runs at 100% Speed, 50% on the second press, and OFF state on the third press.I also added a Type C Port for charging input.Īttiny13A is connected with the Gate of A04406 IC through a 10K Resistor, we control motor speed by providing the gate a PWM Signal through the Attiny MCU.Īs for Flashing the Attiny, I've added a CON6 Header Pin with ISP Pins of Attiny so I could connect a programmer with it to burn the bootloader and upload code in it. TP4056 contains two indicator LEDs, RED and BLUE, red is for low battery and Blue is for full charging. ![]() Rule 2// The screw holes between the two fans must be 15mm width on the radiator for either 120mm or 140mm UNI FAN.It consist of three parts that include a TP4056 IC Setup for charging Lithium cell properly, an Attiny13A MCU Setup that is the brain of this project, and the A04406 IC Setup that is configured in MOSFET as a switch setup for controlling the load which is in our case the DC Motor. Rule 1// The tubes of the radiator must avoid the tenon of the UNI FAN and be at the safe area, which is in grey in the image. Radiators that doesn’t follow bellow rule:.CORSAIR Hydro Series™ H110i GT 280mm Extreme Performance Liquid CPU Cooler.CORSAIR iCUE H115i RGB PRO XT Liquid CPU Cooler.Listed radiators are known not compatible with UNI FAN.To connect more devices, please update to L-Connect 2 (reference to update guide) and use 2 or more controllers. Do not connect more than 10 UNI FANs (device up to 21W) to the controller (UNI HUB) when performing white static color.(Update your motherboard BIOS if necessary) Please enter your motherboard BIOS and set the correspondent fan header at PWM mode.Please note that the single-pack version does not contain this controller. To control all 16 UNI FANs (4 fans each cluster) in one go, a controller is needed, no matter control with L-Connect software or sync to the motherboard. Purchase a three-pack SL120 or a two-pack SL140(including a controller) as the starter kit for fully experienced UNI FANs with L-Connect. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |